IFRC Siding Master Test: Power Tools

IFRC Siding Master Test: Power Tools

Time limit: 0

Test Summary

0 of 10 Questions completed

Questions:

Information

You have already completed the test before. Hence you can not start it again.

Test is loading…

You must sign in or sign up to start the test.

You must first complete the following:

Results

Test complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%
Power Tools 0%

1
2
3
4
5
6
7
8
9
10

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
OSHA requires which of the following on residential construction sites where nail guns, ladders and power saws are in use: (check all that apply)
- Hard hat, high impact eye protection safety glasses or goggles marked ANSI 87.1, hearing protection (earplugs or earmuffs)
- Safety shoes
- A yellow water cooler
- Tarps over all plants
Question 2 of 10

2. Question
PPE refers to:
- Perfectly Plumb Entrance
- Personal Preference Enabled
- Personal Protection Equipment
- Proud Protrusion Element
Question 3 of 10

3. Question

Category: Power Tools
The two fundamental Nail Gun Triggers are:
- 6.4 pound and 4.5 pound
- Sequential and Contact
- Single Action and Double Action
- Thermoplastic and Spring Steel
Question 4 of 10

4. Question

Category: Power Tools
The correct circular saw blade type for cutting Fiber Cement: (check all that apply)
- Minimizes dust and has fewer teeth
- Uses carbide abrasive
- Utilizes a diamond abrasive
- Is reversible
Question 5 of 10

5. Question

Category: Power Tools
The location of the job site cutting station should be: (check all that apply)
- Downwind from the home and workers
- Outdoors in a well-ventilated area
- Silent between the hours of 10pm and 7am
- Located in the quietest spot on the property
Question 6 of 10

6. Question

Category: Power Tools
When cutting Fiber Cement building material, you should always: (check all that apply)
- Hold your breath until the saw stops
- Use a filter mask
- Wear eye and ear protection
- Add 1/8 inch (0.125in) to each cut
Question 7 of 10

7. Question

Category: Power Tools
Faulty power tools should be:
- Donated to a good cause
- Tagged as broken and set aside for repairs or disposal
- Fixed within a year
- Used to hold down tarps
Question 8 of 10

8. Question

Category: Power Tools
The number one cause of injury involving nail guns is due to:
- Not letting go of the held board in time
- Accidental or double-firing contact triggered gun
- Dropped on someone from above
- Falling off a ladder while reaching
Question 9 of 10

9. Question

Category: Power Tools
Contact Triggers versus Full Sequential Trigger Nail Gun: (check all that apply)
- Contact Trigger is 10 percent faster
- Full Sequential Trigger is much safer
- Overall job productivity impact is more than two percent
- Total job productivity is not affected/less than two percent
Question 10 of 10

10. Question

Category: Power Tools
The operator of the Fiber Cement cutting station, or the “cut man”, should: (check all that apply)
- Have approved eye and ear protection
- An appropriate dust mask, a HEPA vacuum saw, or a fan to clear silica dust away from himself, home and other workers
- A saw fitted with a fiber cement saw blade
- A 100psi oxygen tank and appropriate dust mask

Login

Accessing this course requires a login. Please enter your credentials below!

Username or Email Address

Password

Remember Me

Lost Your Password?